![]() Attach your front stops and then drill weep holes using a paddle drill bit.You will need to cut the frame pieces and use them as stops for holding the fence according to the measurements mentioned above.Remaining stepsįollowing are the remaining steps with brief details. Make it flush at the top and screw it into the place. Now it’s time to slide your sleeve right over the post and have its front face parallel to the fence line. Sandwich them right between the back and front pieces and use your nail gun (1.25-inch nails) for securing the assembly. Step 6 – Assembling the sleevesĪfter that, you need to assemble the sleeves by applying PU glue right to the lower sleeve blocks’ edges. After ripping, you can cut the pieces with a mitre saw. You can use a circular saw for ripping the blocks to about 3.75-inch and a full-length piece of 5.125-inch. Step 5 – Cutting the pieces of post sleevesįor constructing the sleeves, sandwich your narrow blocks on the sides where your fence panels connect right between those full-length wider pieces. You can tack a scrap to the front face of your post right to the stand and make sure it stays in touch with the mason’s line. Here, you can clamp a couple of furring strips for adjacent sides for propping up the post within the hole. For getting the right height, you can always add or subtract the amount of stone according to your preferences. It’s time to pour about 6 inches of drainage stone right into the hole and tamp it with your post. Begin from the bottom and extend it right above the concrete area, but keep it below the ground level. You can wrap a section of your post using a flashing (self-adhesive). You have to prevent water from seeping into the wood if you are using concrete. Mark its depth with painter’s tape for reference. However, if you have solid sand, you can sink your post in concrete. Make sure to go beyond the first line and set at least ⅓ of your post within the crushed stone and soil, which works pretty fine. This is where you will have a 90-degree angle on your triangle. Cross the line of the tap until you have 4 and 5-foot marks. Now find the 5 feet mark on your tape and angle it from your second stake towards the mason line. Just mark it about four feet away from the stake. Make sure to tie the mason’s line to your first steak and stretch it out roughly perpendicular to your house. Stick the second one in about three feet from the first one right along your foundation. You can stick one stake for your triangle’s corner, and this will be the point where you will stick your first post. Step 1 – Positioning the lineįor squaring the fence line to your house, you will have to mark a right-angle triangle extending from your foundation. Sidepiece 4.375-inch wide (full-length).Front piece 5.125-inch wide (full-length).Sidepiece 3.625-inch wide (full-length).Back piece 5.125-inch wide (full-length).Front piece 5.125inch wide (full-length). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |